Tools
Phillips Screwdriver
*1
Microfiber Cloth
*1WARNING: Please switch to FAN MODE before cleaning to prevent burns from touching the heating element during disassembly.
Make sure to unplug the tower heater fan before cleaning. Safety is always the priority.
Remove the screw at the bottom of the rear grille with a Philips screwdriver in the counter clockwise direction. Then pull down the grille.
Pull the rear grille out through the handle to remove it.
Remove the screw at the bottom of the impeller in the counter clockwise direction. Please keep the screw with care.
Lift the impeller and tilt it in a certain angle. Then pull out the impeller and wipe the interior of the tower heater fan.
Rinse the rear grille and the impeller. Make sure they are completely dry before reassembling.
Insert the impeller to the top of the heater fan. Then align the axis at the bottom as shown. Install the screw back in the clockwise direction.
Insert the grille into the main body and lift it up. Finally, install the screw back in the clockwise direction. Now, the heater fan is ready for use.
Was this article helpful?
Not Helpful
Helpful